Premier GB-ENCL32 Spezifikationen PDF herunterladen (Seite 7)

GB-ENCL2

Determining the Mounting Hardware

Step 1. Insert a small straw or toothpick into the threaded inserts

found on the back of the flat panel.

Step 2. Use a pencil to mark the depth of the threaded insert on

the small straw or toothpick.

Step 3. Mark the straw or toothpick 1/8” above the depth of the

threaded insert, as shown in Figure 1.

Step 4. Insert the small straw or toothpick into the remaining

threaded inserts to compare and verify their depth using the straw

or toothpick’s 1/8” allowance mark.

Step 5. Locate the correct diameter screw for the threaded insert.

Step 6. Test each size of the screws provided.

The correct screws should thread easily into the mounting point

and not pull out when tension is applied.

If your selected screw is longer than the

1/8” allowance marking on the thread depth

indicator, do not use this screw. The screw

length must not bypass the marking. If so, select

another screw size (Figure 2 and 3) until you find

the screw the comes closest to your mark without

going past the marking.

SmallStraworToothpick

Small Straw

or Toothpick

Small Straw

or Toothpick

Marking the 1/8”

Allowance

Depth Plus 1/8” Allowance

Mark

Depth Plus 1/8” Allowance

Mark

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Keine Kommentare

Premier GB-ENCL32 Spezifikationen Seite 7